REMKO WLT 25 - Manual (Page 7)

Keys on the remote control
"ON / OFF" key
Actuate the key to switch
the unit on.
The POWER indicator
for the unit illuminates
"FAN" key
(Fan speed)
Set the desired fan speed with
the help of this key.
The following 4 speeds are
available:
HIGH, MED, LOW, AUTO
(automatic speed).
"TM" key p and "TM q" key
(timer operation)
You can program the switching
on and off within the next 18
hours with the timer function.
"SLEEP" key
(night temperature increase)
If the sleep function is activated
then the set room temperature
is increased by 1 °C. Renewed
actuation of the SLEEP key
resets the function.
"MODE" key
(Modes 1 to 5 )
The room air conditioner
provides 5 modes:
1. AUTO mode:
This mode maintains the
temperature at the preset value.
The mode LED changes colour
periodically between yellow to
green for a request for cooling,
or from yellow to red for a
request for heating.
It is essential that the necessary
carrier medium can flow quickly
through the pipe network. If
1 Max. distance 6 m
Keys on the remote control
the unit is in AUTO mode and
the medium is only available
after a delay then this will result
in a fault shut-down.
The system will not switch back
on again automatically.
2. FAN mode:
Air circulation without cooling
or heating mode can be
implemented in this mode.
3. COOL mode:
In this mode, the warm air
in the room is cooled down
to the preset temperature.
The mode LED for the cooling
mode starts to illuminate green.
4. DRY mode:
In this mode, the room is
mainly dehumidified, the set
temperature is maintained.
5. HEAT mode:
In this mode, the unit heats
the colder air in the room to
the preset temperature.
The mode LED for the heating
mode starts to illuminate red.
Only with cooling / heating
systems with warm operating
medium (water).
"TMP" p key and "TMP" qkey
The desired temperature can
be adjusted in 1 °C steps within
a range from 16 °C to 30 °C
with the temperature key.
"CANCEL" key
The timer operation can be
stopped with the Cancel key.
"SWING" key
The oscillating fins improve
the air distribution in the room
when switched on.
max. 6 m
Help save on energy consump-
tion in stand-by mode! If the
device, system or component
is not in use, we recommend
disconnecting the power sup-
ply. Components with a safety
function is excluded from our
recommendation!
TIP
7