REMKO WLT 25 - Manual (Page 13)

Cleaning the housing
1. Disconnect the power supply
to the unit.
2. Open and fold the intake grill
on the front side upwards.
3. Clean the grill and housing
using a soft, damp cloth.
4. Switch the power supply back on.
Air filter for indoor unit
Clean the air filter at intervals
of no more than 2 weeks. Reduce
this interval if the air is especially
dirty.
Cleaning the filter
1. Disconnect the power supply
to the unit.
2. Open the front side of the unit
by folding the guard upwards
and allowing it to engage.
3. Lift the filter up slightly and pull
it out from underneath.(Fig. 2).
4. Clean the filter using a normal
vacuum cleaner (Fig. 3).
Turn the dirty side until it faces
up.
5. Dirt can also be removed
by carefully cleaning with
lukewarm water and mild
cleaning agents.
Turn the dirty side downwards
for this (Fig. 4).
6. If water is used, let the filter
dry out properly in air before
replacing it in the unit.
7. Carefully insert the filter.
Ensure that it locates correctly.
8. Close the front side as described
above in reverse order.
9. Switch the power supply back on.
10. Switch the unit on again.
Cleaning of condensate pump
(accessory)
An optional integrated or separate
condensate pump may be in
the indoor unit, which pumps out
any accumulated condensate into
higher positioned drains.
Observe the care and maintenance
guidelines in the separate
operating manual.
2 Fold the guard upwards 3 Cleaning using a vacuum cleaner 4 Cleaning with lukewarm water
13