OnLine Power Telecommunication - Manual (Page 20)

OnLine Power
1-5
REV A
1-4 MOUNTING FEATURES
Pad or Floor Mounting
PBC-II shall mount on a concrete pad, outdoor/indoor. The pad rail mounting comes with the hardware required.
The rails can be in-line with door or crossways to door.
Pole or Wall Mounting
PBC-II can be Pole or Wall mounted. The mounting brackets are optional and need to be ordered. Select options at
the time of purchase of individual units. The part numbers for these options are part of Appendix B of this manual.
1-5 SAFETY COMPLIANCES
The PBC-II units are UL listed and evaluated for compliance to standards for UL 1778 and cUL listed and evaluated
fro compliance to standards for CAN/CSA - C22.2-107.1.
The unit is evaluated by UL for outdoor use to be type 3R (for North American) and IP34 (for International)
The PBC-II units are tested and evaluated to be in compliance by ITS for followings
• IEC 60950
• IEC 600529 (IP34)
• EN 55022 (CISPR)
• GR-1089-CORE: 1997 (Section 3, Rediated immunity and conduited immunity)
• IEC 61000-4-2: 1999
• IEC 61000-4-3: 1998
• IEC 61000-4-5: 1995
• IEC 61000-4-6: 1996
• CFR NO. 47 Telecommunication: Oct 1, 1999 FCC Part 15, Subpart B, Class B
1-6 OTHER IMPORTANT DESIGN FEATURES
1-6-1 Modularity of Internal Components
The cabinet contains two physical assemblies; The Electronic Tray and Individual Batteries.
The Electronic Tray contains the UPS System.
1-6-2 Electronic Tray
The electronic tray can be accessed after removal of front panel, held by 4 captive screws in four corners. The
electronic tray consist of two levels and a front section. The front section contains breakers, receptacles, display
lights etc... The two levels inside contains UPS and electronics. Details of the connectors are shown in Section 3
for electrical wiring of unit.