Nortec LINKS XPS MH - Manual (Page 8)

5 | Links XPS for MHTC
MHTC Flow Models:
1 On MHTC Flow models, Links XPS replaces the remote fault relay board. Remove the
remote fault relay board indicated in Figure 3 and disconnect the cable.
Underneath the remote fault relay board, the 4 holes for the XPS module and two holes for
the XPS transformer should be visible. Depending on the revision of the backplate these
holes may be in different configurations or may not be present at all. In the case of the
latter, drill 4x ¼” holes to accommodate the XPS module. Subsequently drill 2x 9/64” holes
to accommodate the XPS transformer.
2 Using the 4 plastic standoffs and plastic screws provided, attach the Links XPS module to
the steel back plate.
3 Secure the XPS transformer using the two #6-32 thread cutting screws.
4 Install the XPS Terminal strip onto the DIN rail at the bottom of the control cabinet as shown
in Figure 1. It may be necessary to remove one or both of the rail locks and shift the entire
control terminal strip over to accommodate the XPS terminal strip.