Network integration, Retrieving xif file instructions – Nortec LINKS XPS MH User Manual
Page 41
Links XPS for MHTC | 38
Network Integration
LonWorks.xif file
To facilitate the integration of a LonWorks unit within a network, it may be desirable to obtain an
External Interface File (XIF). Files of type .xif are used to convey the resources, specific objects
and data types which a LonWorks device possesses. The .xif file allows a network integrator to
simulate the presence of a networked humidifier even if it is not yet physically connected to the
network. In fact, if the integrator has the .xif files of all network devices, a complete system
could be simulated and configured off-line. Once the configuration is done, the integrator's
software tool can be connected to the actual system and the configuration information can be
downloaded.
Retrieving XIF File Instructions
The XIF file can be retrieved directly from the Links XPS Module. A Windows based laptop and
an Ethernet cable are required for this process.
This process requires the “Remote User Interface” tool from Protocessor described earlier in
this manual. It is available by visit
and download and install the “Utility” software.
Once this software has been installed, follow the following procedure:
1. Locate desired MASTER humidifier that contains the Links package. Ensure unit is powered
on and remove the panel on the RIGHT side of the humidifier. Locate the Links package
inside of the unit.
2. For LINKS XPS packages (gateway device on its own), connect the CAT5 cable directly into
the Ethernet port on the gateway.
3. Connect other end of CAT5 cable to the Ethernet port on the laptop.
4. Run the “Remote User Interface” utility by double clicking the shortcut on your desktop (or
Start>Programs>Fieldserver Utilities>Remote User Interface)
5. The program should automatically recognize connected humidifier and bring you to the
“Main Menu”. If it does not, contact Nortec Technical Services at the number on the back
cover of this manual.
6. Type “u” for upload.
7. Type “o” for other. (A warning will appear, press any key to continue.)
8. Type “r” for remote.
9. Enter “fserver.xif”’ and hit the ‘enter’ key.
10. Type “u” to initiate upload from the gateway to the laptop.