Nortec LINKS XPS MH User Manual
Page 40
37 | Links XPS for MHTC
To edit the IP address, press the 1 key, type in the desired address, and then press Enter once.
Repeat the process for the Netmask (selection 2), and the Gateway (selection 3). For most
reliable performance, activating DHCP is not recommended.
When the IP address change is completed press Esc to return to the main menu. Next select !
(Hold the Shift key and press the 1 key simultaneously) to restart the module causing the
changes to take effect.
Figure 34: Restarting XPS Module
Press any key to exit this screen. The module will reboot and may take up to 1 minute to fully
restart. If you changed the IP address significantly, the module may no longer be reachable with
your IP address settings resulting in the same error described in step 4
To rectify this, change your IP address to a unique address in the same domain as the one you
entered for the Fieldserver by following the instructions in step 4. Once communication has
been re-established, you can quickly verify the change was successful by noting the address
displayed under “Fieldservers discovered on the network”.
When completed, be sure to restore your existing IP address settings for your computer
following the instructions in step 4 and substituting the settings you had noted originally.