NavCom SR-7120 Rev.A - Manual (Page 98)

Safari Network User Guide
5-10
8. Next you are prompted to enter the baud rate for the
port. Options are:
• 115.2 Kbps = 0
• 57.6 Kbps = 1
• 38.4 Kbps = 2
• 32.7 Kbps = 3
• 19.2 Kbps = 4 • 9.6 Kbps = 5
• 4.8 Kbps = 6
• 2.4 Kbps = 7
• 1.2 Kbps = 8
• 300 bps = 9
9. Enter the baud rate using the number value (0 – 9).
10. Next enter the Data Type for the port. Options are:
• 1-Data
• 2-Debug
• 3- GPS
11. Enter the data type using the number value (1,3).
This is normally set to Data.
12. You will then be prompted to enter the Service ID for
the port (this corresponds to the service ID configured
in service configuration for the transmit channel).
13. For a Remote to Remote service, you will also be
prompted to enter a second service ID (for the
service’s receive channel).
14. Enter the Ultimate Destination ID for the port, which
is the RU ID that will receive this port’s transmission.
15. Enter the Ultimate Destination Port for the port
(COM1, COM2 or COM3), which is the port on the
Destination ID that will receive this port’s
transmission.
You can now choose to configure another port, in which
case repeat steps 1 through 10, or select 4) exit when
done. The change will take effect after the RU logs on.