NavCom SR-7120 Rev.A - Manual (Page 81)

Safari Network User Guide
Remote Configuration - Adding an RU
At the Network Management menu, select:
4) Remote Configuration
The Remote Configuration menu appears like the
following:
Image 4-16: Remote Configuration Menu
At the Remote Configuration menu, select:
1) Add Remote
and you will be prompted to enter the Unit ID (the logical
radio ID) for the radio unit by typing its value and pressing
the Enter key. For RUs, the Unit ID can be chosen from
101 to 599 (100 is reserved for NCU).
Then you will be prompted to enter the physical ID of the
unit (as it is listed on the RU label).
When you are prompted whether or not to enable DHCP,
enter y or n as appropriate. If you are using a router with
its DHCP server enabled, enter y to enable the DHCP on
remotes. If you enter n, you will be prompted to enter
your assigned remote’s IP Address and Subnet Mask.
Then you will be prompted to enter the Output Power
level (which is usually the same as that set for the NCU).
Use 63 for the maximum power level permitted by the
FCC for each data rate. Lower power level can be set by
using 62 - 0.
4-19