NavCom LAND-PAK Rev.E - Manual (Page 97)

LAND-PAK
™ User Guide – Rev. E
5-95
RTK-X Tolerance
The receiver must have attained an RTK fix and have
tracked StarFire Dual mode before an RTK-X position
can be obtained. Both of these caveats normally
occur within 5 minutes of normal RTK operation.
Perform these steps to set the RTK-X (RTK-Extend)
tolerance parameters:
1. Log on to FieldGenius and select a project or
create a new one.
2. On the Instrument Selection dialog box (refer to
Figure 40), select GNSS Rover.
3. Click Edit.
4. On the GNSS Profile dialog box (refer to Figure
54), select Tolerance Setting [RTK-X].
5. On the Tolerance 2 dialog box (refer to Figure
56), set the parameters and click OK.

The recommended setting for a short
baseline is:
Position (H): 3cm
Position (V): 6cm
When setting the above parameters,
keep the selection StarFire Dual on
the Solution drop-down list box.