NavCom LAND-PAK Rev.E - Manual (Page 102)

LAND-PAK
™ User Guide – Rev. E
5-100
Set the Active Tolerance
To set a tolerance as the active tolerance, perform
these steps:
1. Open FieldGenius and select a project or create a
new one.
2. On the Instrument Selection dialog (refer to
Figure 40), select GNSS Rover.
3. Click Edit.
4. On the GNSS Profile dialog (refer to Figure 60),
click Active Tolerance [StarFire].
5. On the Select Tolerance dialog (refer to Figure
61), select an active tolerance, and then click OK
on the GNSS Profile dialog box.
Figure 60: GNSS Profile/Active Tolerance [StarFire]