NavCom LAND-PAK Rev.E - Manual (Page 50)

LAND-PAK
™ User Guide – Rev. E
3-48
A 3.7V 5600mAh Lithium-Ion battery pack powers the
Nautiz X7. It can provide approximately 8 to 12 hours
of operating time on a full charge (depending on
power management and use).
There is no charging indicator on the Nautiz X7
battery charger.
Charge the battery pack only with the
supplied battery charger kit; otherwise,
damage to the battery pack could occur.

Charge the battery pack in the Nautiz X7
until it is fully charged before first use.
Installing the Nautiz X7 Battery
1. Twist the handle and remove the battery chamber
door from the back of the Nautiz X7.
2. Insert the batteries securely in the chamber.
3. Replace the battery chamber door and twist the
handle to lock it in place.
Charging the Battery
Refer to Figure 16 for the steps below:
1. Plug the DC cord of the AC adapter into the
power connector of the Nautiz X7.
2. Plug the female end of the AC power cord into the
AC adapter and the male end into an electrical
outlet.

The charge indicator glows amber when
charging is in progress and green when
the battery is fully charged.
Do not disconnect your device from AC
power until the battery is fully charged.