Microcom 400 - Manual (Page 51)

Chapter 5 Printer Commands
400 Operators Manual 43
^A ^D COMMAND
23 Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******. Always 0
******.) Always 0
*****.))
Always 0
****.)))
Always 0
***.)))) Always 0
**.))))) 1=Send Response After Print
** 0=No Response After Print
*.)))))) Always 0
.)))))))
1=Disable Extended ASCII, 0=Enable
Position:
1 Extended ASCII: If enabled, characters over 7F hex will be processed.
2 Always 0
3 Response After Print: If enabled, an enquiry response will be sent back through
the serial port after every print.
4 Always 0
5 Always 0
6 Always 0
7 Always 0
8 Always 0