beautypg.com

Metz MECABLITZ 58 AF-2 digital Nikon User Manual

Page 121

background image

121

ķ

Group B:
• Matrix-controlled fill-in flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:

BL

Group C:
• 3D multi-sensor fill-in flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:

BL

Group D:
• D-TTL 3D flash mode.
• Settings made on flash unit.
• Display on flash unit after saving:

BL

Group E:
• i-TTL BL flash mode (not with Coolpix cameras).
• Settings made on flash unit.
• Display on flash unit after saving:

BL

Some cameras do not support TTL fill-in flash mode in combination with
SPOT exposure metering. This flash mode will then either be automati-
cally cancelled or cannot be activated in the first place. In this case, nor-
mal TTL flash mode, D-TTL or i-TTL modes will be set (see camera’s opera-
ting instructions).

TTL

TTL

TTL

TTL

5.4 Automatic flash mode

In the automatic flash mode A, the flash unit sensor measures the light that

reflects back from the subject. The sensor has a coverage of about 25°, and

only measures the light for the time a flash is fired by the mecablitz. The flash is

cut off as soon as sufficient light has been emitted for correct exposure. The sen-

sor of the mecablitz has to be directed at the subject.
The maximum range is shown on the LC display. The shortest shot distance is

approximately 10% of the maximum distance range. The subject should be loca-

ted within the middle third of the distance range shown on the LC display to

allow the electronic system sufficient leeway for compensation.
Setting procedure:

• Press the

button until „Mode“ flashes on the

LC display.

• Set the flash mode

using the

and

arrows. The flash mode selected is then highlighted.

The setting takes effect immediately.

• Press the button

to change the LC display back

to the normal view. If the button

is not pressed,

the display will change back to the normal view after

about 5 seconds.

If the shot was properly lit, the correct exposure indica-

tion ተ will flash „OK“ for about 3 seconds (see 13).

ĭ

İ

A

Mode

Mode

TTL BL
A
M

İ

ĭ

Set

A

Mode

Para

Sel

F 4.5

AZoom 70

14 m

ISO 200

A

709 47 0159.A1 58AF-2 Ni Print 26.07.2010 14:13 Uhr Seite 121