Metz MECABLITZ 52 AF-1 digital Canon - Manual (Page 158)

158
k
☞
E TTL
INFO EV
0,7 -7,9 m
Z OOM 35 F5,6 m m
E TTL
INFO EV
- 1
0,7 -7,9 m
Z OOM 35 F5,6 m m
-1 1/3
-1
-2/3
Setting procedure
• Press the
sensor buttons on the touch
display as many times as it takes for the
partial light output selection to appear.
• Press the sensor buttons on the
touch display and set a correction value.
• Press the selected correction value on the
touch display, e.g .
The setting will take effect immediately.
Manual flash exposure correction is only pos-
sible in TTL flash mode if the camera sup-
ports this function (consult the camera’s ope-
rating instructions)!
If the camera does not support this function,
the adjusted correction will have no effect.
For some camera models, the manual flash
exposure corrections must be adjusted on
the camera. If this is the case, no correction
value will appear on the flash unit display.
After the shot, remember to cancel the TTL
flash exposure correction in the camera!
Strongly reflecting objects in the motif can
have a negative impact on the camera’s
automatic exposure. The photograph will be
underexposed. Remove reflecting objects or
set a positive correction value
-1
EV
9 Special functions
Depending on the camera model, various
special functions are available. For this pur-
pose, data exchange must first occur bet-
ween the flash unit and camera to access
and set the special functions, for example by
tapping the shutter release.
The setting must occur immediately after
accessing the special functions since other-
wise the flash unit automatically switches
back to normal flash operation after a few
seconds!