Metz MECABLITZ 15 MS-1 digital - Manual (Page 76)

76
ķ
set if a fixed channel is not used in
the remote system.
In the case of “CHANNEL ALL”, all
set channels are activated.
In the remote operating modes,
groups can be set in addition to the
channels (CHANNEL) in order to con-
trol the desired slave flash unit of a
specific group.
The setting of groups (GROUP A, B,
C) is only possible in Canon, Nikon
and Olympus remote control modes.
Setting a channel (CHANNEL) and a
group (GROUP) in a camera-specific
remote system
• Keep the button “AF/SELECT” ቤ
pressed on the flash unit until the
following message appears in the
display:
• Press the button on the flash
unit. In the display appears::
• Press the button on the flash
unit. The most recently used setting
appears in the display, e.g.:
S E L
S E L
• Press the button on the flash
unit. In the display appears:
• Press button and select the
desired channel (CHANNEL ALL –
CHANNEL 1..4).
• Press button , the selected
remote channel is set. In the display
appears:
• Press button and select the des-
ired group (GROUP A, GROUP B,
GROUP C).
• Press button and the desired
group is set.
• Press button , the selected remo-
te channel and remote group are
set.
5 Manual wireless slave
mode
Even when cameras are used without
a camera-specific remote system
,
wireless release of one or more slave
flash units is possible.
OK
S E L
Ī
S E L
Ī
S E L
S E L Ī
S E L E C T
⊃
̇
S E L Ī OK
M O D E L L I N G
L I G H T
O F F O N
S E L Ī OK
SYSTEM
OLY REMOTE Ģ
Ch ALL Gr A
CHANNEL ALL
S E L Ī
CHANNEL 3
S E L Ī
GROUP A
S E L Ī
S E L Ī OK
SYSTEM
OLY REMOTE Ģ
Ch 3 Gr A
1:1
Ĩ Ī
OLY Ch3 GrA
GROUP A
S E L Ī
☞
708 47 0018.A3 15 MS-1 01.04.2010 9:56 Uhr Seite 76