Measurement Computing 6K-SSR-RACK08 - Manual (Page 18)

6K-SSR-RACK08 User's Guide Installing the 6K-SSR-RACK08
Figure 2-4. 6K-SSR-RACK08 board jumpers and external power connectors
Power source
Set the power source with jumper JP1 (labeled POWER IN ). You can power the 6K-SSR-RACK08 using one of
the following sources.
ƒ the 6000 Series control board’s internal +5 V power supply (default)
ƒ your computer’s +5 V power supply, or external +5 V supply (power cable supplied)
ƒ AC adapter (supplied)
Figure 2-5
Figure 2-5. Power source jumper JP1 configurations
shows the POWER IN jumper configured for each power source.
+5BD
Internal power
from the MCC board
External power from
the computer’s power supply
+5PC
External power from
an AC adapter
9V EXT
Internal power
from the MCC board
External power from
the computer’s power supply
External power from
an AC adapter
External +5 V PC power connections
You can power the 6K-SSR-RACK08 with your computer’s +5 V power supply using the C-PCPOWER-10
cord that was shipped with the board. Each end of the cable has a keyed MOLEX type connector. To connect to
your computer’s internal power connectors, do the following:
1.
2.
Turn off power to the computer and remove the cover.
Connect one end of the C-PCPOWER10 power cord to one of your computer’s internal power connectors.
If necessary, refer to your computer's user manual for the location of the power supply connectors.
2-9