Measurement Computing 6K-SSR-RACK08 - Manual (Page 17)

6K-SSR-RACK08 User's Guide Installing the 6K-SSR-RACK08
Connecting to your 6000 Series control board
Perform the following procedure to connect the 6K-SSR-RACK08 to the 6000 Series control board.
1.
2.
3.
o
o
Turn off your computer and open the cover.
Install your PCI-DAS6000 Series or PCI-DAC6700 Series board in the computer.
Connect the digital signal cable from one of the interface connectors on the 6K-SSR-RACK08 to the
100-pin I/O connector on the 6000 Series control board.
C100MMS-x cable : Connect one end to either 100-pin interface connector ( P12 or P11 ) on the 6K-
SSR-RACK08. Connect the other end to the 100-pin interface connector on the 6000 Series control
board.
C100HD50-x cable : Connect the 50-pin end (stamped Pins 51 to 100 ) to either 50-pin connector ( P9
or P10 ) on the 6K-SSR-RACK08. Connect the 100-pin cable end to the 100-pin interface connector on
the 6000 Series control board.
External power is required when using the C100HD50-x cable
The C100HD50-x cable does not provide power to the 6K-SSR-RACK08. If you use the C100HD50-x cable,
power the 6K-SSR-RACK08 with an external power source.
4.
o
o
To connect other accessory boards or devices to your 6K-SSR-RACK08, use the remaining 100-pin
interface connector and/or the two 50-pin connectors for the connection(s). The following typical
configurations are possible:
When using a C100MMS-x cable, you can use a second C100MMS-x cable to daisy chain to an SCB-
100 accessory board, OR you could use a C50FF-x cable to daisy chain to a 50-pin accessory board.
When using a C100HD50-x cable, you can use a C50FF-x cable to daisy chain to a 50-pin accessory
board.
Configuring the 6K-SSR-RACK08 board
The 6K-SSR-RACK08 has jumpers that you set to configure the power source and relay logic control. Factory-
configured default settings are listed in
. Table 2-6
Table 2-6. Default hardware configuration
Board label Description Default setting
POWER IN
JP1 Sets the power source to one of three options:
ƒ
+5BD: +5V power from the connected 6000 Series control board.
ƒ +5PC: power from the computer’s internal power supply.
ƒ 9V EXT: power from an AC adapter.
+5BD
JP2 Jumper to set the I/O module type for SSR modules 1-4. output
JP3 Jumper to set the I/O module type for SSR modules 5-8. output
JP5 Jumper to set the I/O module parity for SSR modules 1-4.
Options are invert (active high) and non-invert (active low). NON-INVERT (active low)
JP6 Jumper to set the I/O module parity for SSR modules 5-8.
Options are invert (active high) and non-invert (active low). NON-INVERT (active low)
Figure 2-4 shows the location of the jumpers and power connectors on the 6K-SSR-RACK08.
2-8