Mathey Dearman CNC Saddle Machine User Manual
Page 99
CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA
Ver 1.0
99
6.7.15 Header Pipe Thickness (Saddle Cut Only) (Figure 6-58)
Figure 6-58 Header Pipe Thickness (Saddle Cut Only) Screen
1. Standard Pipe Thickness Selection – With this radio button checked only standard pipe thicknesses
can be selected from the list below (2)
2. Standard Pipe Thickness Selection – Select the standard thicknesses of the pipe that the branch will go
into. Thickness is limited by the diameter of the pipe.
3. Custom Pipe Selection – Select the custom thicknesses of the pipe that the branch will go into in inches.
Only one selection can be made at one time: Standard or Custom. Thickness is limited by the diameter of
the pipe.
4. Down Button – Lower the selected value of the custom pipe thicknesses by one increment.
5. Custom Pipe Size – If the ‘Custom Pipe Thickness’ (2) radio button is selected this will be the custom
pipe thicknesses in inches.
6. Up Button – Raise the selected value of the custom pipe thicknesses by one increment.
7. Back Button – Go to the previous cut selection screen.
8. Next Button – Go to the next cut selection screen.