Mathey Dearman CNC Saddle Machine - Manual (Page 93)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
93
6.7.9 Centerline Offset (Square Hole Only) (Figure 6-52)
Figure 6-52 Centerline Offset (Square Hole Only) Screen
1. Centerline Offset Up Button – Raises the amount of centerline offset by one increment. The maximum
value is limited by the size of the header pipe.
2. Branch Angle Value –Value of the offset of the branch pipe in relation to the header pipe in inches. The
zero point of this value is defined when looking top down on the pipe and the branch pipe is equally
spaced between the two sides. Raising the value of the centerline offset will move the branch pipe in the
positive x direction when the positive z direction is facing the right. If looking top down with the machine
on the pipe raising the value of the centerline offset will move the location of the branch pipe in the
direction of the green button on the electrical box and vice versa.
3. Branch Angle Down Button – Lowers the amount of centerline offset by one increment. The minimum
value is limited by the size of the header pipe.
4. Back Button – Go to the previous cut selection screen.
5. Next Button – Go to the next cut selection screen.