Mathey Dearman CNC Saddle Machine - Manual (Page 100)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
100
6.7.16 Branch Pipe Diameter (Saddle and Saddle Hole Only) (Figure 6-59)
Figure 6-59 Branch Pipe Diameter (Saddle and Saddle Hole Only) Screen
1. Nominal Pipe Size Selection – With this radio button checked only nominal pipe sizes can be selected
from the list below (2)
2. Standard Pipe Diameter Selection – Select the nominal size of the pipe that the cut will occur on if a
saddle or the size of the branch that will go into if a saddle hole. Pipe size is limited by the machine being
used (See Table 3-3).
3. Custom Pipe Selection – Select the custom size of the pipe that the cut will occur on if a saddle or the
size of the branch that will go into the saddle hole in inches. Only one selection can be made at one time:
Nominal or Custom. Pipe size is limited by the machine being used (See Table 3-3).
4. Down Button – Lower the selected value of the custom pipe diameter by one inch.
5. Custom Pipe Size – If the ‘Custom Pipe Diameter’ (2) radio button is selected this will be the custom pipe
size in inches.
6. Up Button – Raise the selected value of the custom pipe diameter by one inch.
7. Back Button – Go to the previous cut selection screen.
8. Next Button – Go to the next cut selection screen.