Mathey Dearman CNC Saddle Machine - Manual (Page 96)

CNC Saddle Machine Parts & Operating Manual 03-0117-MSA 03-0117-1SA 03-0117-2SA Ver 1.0
96
6.7.12 Square Width (Square Hole Only) (Figure 6-55)
Figure 6-55 Square Width (Square Hole Only) Screen
1. Square Width Up Button –Increases the width of the square cut by one increment. The maximum value
is limited by the diameter of the pipe being cut on.
2. Square Width Value – Value of the width of the square cut in the x direction in inches. This value by
default starts at the zero position.
3. Square Width Down Button –Decreases the width of the square cut by one increment. The minimum
value is limited by an internal value.
4. Back Button – Go to the previous cut selection screen.
5. Next Button – Go to the next cut selection screen.