Dish Network 942 - Manual (Page 95)

Chapter 10
88
Controlling Other Components
Using the Remote Control with Other Components
This section describes how to use each button on the remote control after programming
the remote to control a TV, VCR, DVD, or tuner/amplifier. The following tables describe
each button and how they are used with the various components (all components or
individual). Refer to Remote Control Modes on page 81 as you read this section. .
Button Used With Description
1
All
Press Mode buttons to set the remote control to operate
one of four components: SAT (satellite receiver), TV (for a
TV), VCR (for a VCR or a DVD player), and AUX
(“auxiliary,” for a second TV, a second VCR, a tuner, or an
audio amplifier). The mode button lights for two seconds
to show you’ve set the remote to that mode. Be sure to
program the remote to control the other components as
described on page 81.
2
All Press POWER to turn the component on or off.
3
TV
Press TV POWER to turn the TV on or off.
4
TV, VCR
Press TV/VIDEO to switch between the inputs on the TV.
Press the TV/VIDEO button to switch between TV and
VCR on modes on the VCR.
5
TV,
Tuner/
Amp
Press MUTE to turn off the sound. Press it again to
restore the sound to the previous level. Be sure to
program the remote to control the component to use this
button. See Controlling Other Components on page 81.
6
VCR Press PAGE UP and PAGE DOWN to change channels.
7
TV, Tuner/
Amplifier
Press VOLUME to raise and lower the volume. Be sure to
program the remote to control the component to use this
button. See Controlling Other Components on page 81.
Chapter 10 Two Color.fm Page 88 Tuesday, June 7, 2005 1:17 PM