Standard Horizon HX-100S - Manual (Page 27)

Page 27 HX100/HX150
6.9 SCANNING
The HX100/HX150 allows the user to select the scan type from “Memory
Scan” or “Priority Scan”. “Memory Scan” scans the channels that were pro-
grammed into Scan Memory and also channels stored in the Preset Channel
(“P0” ~ “P9”). “Priority Scan” is similar to the “Memory Scan” scan, however
it scans the priority channel (channel 16) and dual watches to channels pro-
grammed in memory scan and preset channel memory. When an incoming
signal is detected on one of the channels during scan, the radio will pause on
that channel, allowing you to listen to the incoming transmission.
6.9.1 PROGRAMMING SCAN MEMORY
1. Turn the transceiver off by pressing and holding the key.
2. Press and hold the key, and then turn on the trans-
ceiver while still holding down the key. “ SET” icon
will appear on top right of the display.
3. Press the or key to select desired channel to
be scanned, then press the key. The “ M” icon ap-
pears on the display, which indicates the channel has
been selected to the scan channel.
4. Repeat step 3 for all desired channels to be programmed into scan mem-
ory.
5. To DELETE a channel from the scan memory, select the channel by
pressing the or key, then press the key. The “ M” icon will
disappear from the display.
6. When you have completed programming scan memory, turn the trans-
ceiver off and on by press and holding the key.
6.9.2 SELECTING SCAN TYPE
1. Turn the transceiver off by press and holding the key.
2. Press and hold the key, and then turn on the transceiver while still
holding down the key.
3. “ SET” icon will appear on the display, indicating the
Menu (“Set”) Mode has been activated.
4. Press the key until “SC” is shown in the bottom right
of the display.
5. Press the or key to select “PS (Priority Scan)”
or “MS (Memory Scan)”. The factory default is “PS (Pri-
ority Scan)”.
Priority Scan: Scans the Scan Memory Channel, Pre-
set Channel, and the Priority Channel
(Channel 16).