Standard Horizon HX-100S - Manual (Page 14)

HX100/HX150 Page 14
Battery Recycling
DO NOT PLACE USED BATTERIES IN YOUR
REGULAR TRASH!
LI-ION AND NI-MH BATTERIES MUST BE
COLLECTED, RECYCLED OR DISPOSED OF
IN AN ENVIRONMENTALLY SOUND MANNER.
The incineration, land filling or mixing of Li-ion batteries with the municipal
solid waste stream is PROHIBITED BY LAW in most areas.
Return batteries to an approved Li-ion battery recycler. This may be where
you purchased the battery.
Contact your local waste management officials for other information regard-
ing the environmentally sound collection, recycling and disposal of Li-ion or
Ni-MH batteries.
4.2.2 BATTERY INSTALLATION / REMOVAL

Open the Battery Cover Latch on the Battery Cover, then remove the
Battery Cover from the radio while pulling the top side of the Battery
Cover.
 Connect the 3-pin ( FNB-124LI for HX150) or
2-pin ( FNB-125 for HX150) connector from the
Battery pack to the battery jack on the trans-
ceiver.
 Install the FNB-124LI (for HX150) or FNB-125
(for HX100) Battery Pack into the radio.
 Install the Battery Cover by carefully aligning
the two tabs on the bottom of the cover with
the slots on the radio, then gently press the top
side of the Battery Cover. Confirm that a Rub-
ber Gasket of the Battery Cover is installed cor-
rectly.
 Close the Battery Cover Latch until it locks in
place with a “Click”.
CAUTION
To insure the HX100/HX150 will not have a
problem with water intrusion, make sure the
battery cover is properly installed and the bat-
tery latch is closed.
Ni-MH Li-ion
HX100
HX150