JB-Lighting Licon FX - Manual (Page 28)

12.02.2010 V1.0 -28-
-> For quick start guide continue with 6.4 Modifying chase parameters
6.3.2 Modifying steps
Press the softkey MODIF (modify) to modify steps. The following menu bar is shown:
6.3.2.1 Deleting steps
To delete a single step select the step to be deleted with the encoder first and then
press the softkey DELST (delete step) to execute the deleting process.
6.3.2.2 Duplicating steps
To duplicate a single step select the step to be duplicated with the encoder first and
then press the softkey DUPST (duplicate step) to execute the duplicating operation.
The new step will be inserted after the step from which the duplicate is made.
6.3.2.3 Block operations
Block operations will delete, copy or shift single steps or a group of steps. Carry out
block operations as follows:
First select the beginning of the block with the encoder.
Then press and hold the softkey BLOCK. Highlight the end of the block with the
encoder (only if the block consists of more than one step). Now release the softkey
BLOCK again.
The block is now highlighted and the following menu bar is shown:
You can verify the highlighting of the block by moving the encoder. Steps are part of
this block, when the field to the right of the current step number will be highlighted.
The menu item B-MOV will only be displayed when the step currently selected allows
moving.
6.3.2.3.1 Deleting a block
Press the softkey B-DEL (block deletion) to delete the highlighted block.
6.3.2.3.2 Copying a block
Select the step to which you want to add the copy. Press the softkey B-CPY (block
copy) to execute the copying process.
6.3.2.3.3 Moving a block
Select the step to which you want to move the block. Press the softkey B-MOV
(block move) to execute the moving process.
6.4 Modifying chase parameters
In order to modify chase parameters, enter the chase STORE or EDIT menu and
press the softkey PARAM (parameter). The following menu bar is displayed: