JB-Lighting Licon FX - Manual (Page 20)

12.02.2010 V1.0 -20-
As illustrated above, the menu item COMB 1 must be displayed inverted and
AUTO 1
must not be displayed inverted. If this is not the case, press the
softkeys COMB 1 and AUTO 1 for activation or deactivation. The menu item
AUTO 1
will only be displayed, when the COMBI-mode is activated (COMB 1
is inverted).
Since this mode requires two faders for the manual fade of a chase, the
second fader can no longer be used to control a separate chase.
3.3.2 Flash
The Licon FX provides the possibility of optionally configuring flash keys of the chase
fader as trigger keys (or Go+) for the respective chase.
-> For quick start guide continue with 3.4 Access
Configure this function by pressing the softkey FLASH.
The following display is shown:
For a more elaborate usage of this function see 6.4.3.2 Manual sequencing via Go
keys
.
The display shows two consecutive chase flash keys that you can configure in one
setting. The designation of the currently selected keys you wish to configure is shown
on the left side of the display. Select the flash keys either with the encoder or by
pressing the relevant flash key. Press the softkeys GO1 and GO2 to toggle between
the flash and trigger (Go+) mode of the keys.
You can see the current mode of the flash keys in the menu bar and in the central
part of the display. If the menu item GO1 or GO2 is displayed inverted, then the
corresponding flash key is used in the trigger mode. Otherwise (no inversion), it is
used as flash key.
3.4 Access
You can create up to five different user profiles for the Licon FX. Thus, different users
may be granted different user rights and unauthorised access to the console is
blocked.
-> For quick start guide continue with 4 Basic control elements
To configure the access function press the softkey ACCES.
The following display is shown:
Activate the password protection by pressing the softkey CHECK. However, you
must enter a master password for the master user profile before this Softkey will be