JB-Lighting Licon FX - Manual (Page 19)

12.02.2010 V1.0 -19-
3.3.1 Manual fade
The Licon FX allows you to use the chase faders in order to perform manual fades.
-> For quick start guide continue with 3.3.2 Flash
To configure this function press the softkey MFADE.
The following display is shown:
For a more elaborate usage of this function see 6.4.3.5 Manual sequencing by chase
faders.
The display shows two consecutive chases that you can configure in this setting. The
designation of the currently selected faders you wish to configure is shown on the left
side of the display. Select the faders either with the encoder or with the flash key that
belongs to the fader of your choice.
You can choose between the following three modes of configuration, the current
setting being shown in the menu bar and in the middle of the display:
-> Combined fader for brightness and fading:
Activate this mode paying attention as to how the menu items are displayed in
the menu bar below:
As you can see in the illustration above, the menu item COMB 1 is not
displayed inverted. In case of inversion, press the softkey COMB 1 for
deactivation.
Since this mode requires only one fader for the manual fade of a chase, the
other fader can be used to control a separate chase.
-> Separate faders for brightness and fading, automatic switching
Activate this mode paying attention as to how the menu items are displayed in
the menu bar below:
As illustrated above, the menu items COMB 1 and AUTO 1 must be displayed
inverted. If this is not the case, press the softkey COMB 1 and/or AUTO 1
for
activation. The menu item AUTO 1 will only be displayed, when the COMBI-
mode is activated (COMB 1 is inverted).
Since this mode requires two faders for the manual fade of a chase, the
second fader can no longer be used to control a separate chase.
-> Separate faders for brightness and fading, manual switching with keys
Activate this mode paying attention as to how the menu items are displayed in
the menu bar below: