Ivoclar Vivadent Virtual v.3 - Manual (Page 6)

G
B
D
tr
an
se
Fa
s.
Instructions for Virtual Tray Adhesive:
1. Be sure that all surfaces of the impression tray are oil-free, clean
and dry.
2. Apply a thin layer of Virtual Tray Adhesive using the brush provided to all
surfaces of the impression tray (metal or plastic) that will come into
contact with the impression material.
3. Allow tray adhesive to dry (approximately 3 minutes).
4. Replace bottle cap immediately.
– Note the warnings in the Virtual Tray Adhesive Instructions for Use!
– Disinfection of Impressions
Impressions made with Virtual impression materials can be immersed in a disinfection solution
(glutaraldehyde 0.5% - benzalkonium chloride 0.5%) immediately for 10 minutes without
distortion.
– Pouring Up Models
The impression may be poured immediately after disinfection, or up to two weeks later,
provided that the impression is stored at room temperature. Dimensional stability is
guaranteed for 14 days. Virtual impression materials are compatible with all popular
dental plasters on the market, e.g. Type 3: Moldano
® (Heraeus Kulzer), Type 4: Fujirock ®
(G.C. International)
– Galvanization
Virtual impression can be silver or copper plated in a galvanic bath.
Special Notes
Vinylpolysiloxanes are chemically resistant. Unpolymerized materials may stain clothing.
Warnings
If uncured materials come into contact with the eyes, rinse with copious amounts of water.
If irritation persists seek medical attention. In case of contact with the skin, wash affected areas
with soap and water.
Storage
– Storage temperatures: 2–28 °C / 36–82 °F
– Shelf life: See expiration date on label and packaging
– Keep away from direct heat sources!
Keep out of the reach of children! For use in dentistry only!
Date information prepared: 08/2011 Rev.2
Ivoclar Vivadent AG, FL-9494 Schaan/Liechtenstein
These materials have been developed solely for use in dentistry. Processing should be carried out strictly according to
the Instructions for Use. Liability cannot be accepted for damages resulting from failure to observe the Instructions or
the stipulated area of application. The user is responsible for testing the material for its suitability and use for any
purpose not explicitly stated in the Instructions. Descriptions and data constitute no warranty of attributes and are not
binding.
V
A
V
Virtual_GI_WE3_573264_Rev2_Virtual_GI_WE3_573264_Rev2.qxd 23.12.11 10:55 Seite 6