Ivoclar Vivadent Zenostar - Manual (Page 56)

56
IPS e.max Ceram on Zenostar T – Staining Technique
IPS e.max Ceram
B
°C
S
min
t
°C/min
T
°C
H
min
V1
°C
V2
°C
Stain and
Characterization firing
403 6:00 60 770 1:00 450 769
Glaze firing 403 6:00 60 770
1:00-
2:00
450 769
Add-on after Glaze firing 403 6:00 50 770 1:00 450 699
If several objects (multi-unit bridges with massive bridge pontics or several full-contour restorations) are fired in one firing cycle, the
heating of the objects in the furnace may be delayed. This delay can be counteracted by either reducing the heating rate or by
extending the holding time at the final temperature.
The heating of the firing chamber depends on the type of furnace as well as the size of the firing chamber!
Firing parameters for IPS e.max Ceram
IPS e.max Ceram on Zenostar T/MO – Layering Technique
IPS e.max Ceram
B
°C
S
min
t
°C/min
T
°C
H
min
V1
°C
V2
°C
L
°C
ZirLiner firing 403 4:00 40 960 1:00 450 959 0
1 st Margin firing 403 4:00 40 800 1:00 450 799 0
2 nd Margin firing 403 4:00 40 800 1:00 450 799 0
Wash firing 403 4:00 40 750 1:00 450 749 0
1 st Dentin-/Incisal firing 403 4:00 40 750 1:00 450 749 0
2 nd Dentin-/Incisal firing 403 4:00 40 750 1:00 450 749 0
Stain firing 403 4:00 60 725 1:00 450 724 450
Glaze firing 403 4:00 60 725 1:00 450 724 450
Add-on with Glaze firing 403 4:00 60 725 1:00 450 724 450
Add-on after Glaze firing 403 4:00 50 700 1:00 450 699 450