Ivoclar Vivadent Zenostar - Manual (Page 32)

32
Finishing
After sintering, the monolithic restorations can be refined and finished with suitable instruments. Please refer to page 25 for further
notes on finishing. In the fabrication of monolithic restorations, appropriate polishing of the surfaces, particularly in the occlusal
region, is very important. This helps to protect the opposing teeth. Failure to observe these guidelines may result in increased wear
(also see Zenostar T – Monolithic restorations fabricated in the Staining Technique).
Stain and Characterization firing
The restorations are stained and glazed in the same way as restorations fabricated in the Staining Technique. Please observe the
notes on page 27.
Firing parameters for the Stain and Characterization firing
The firing parameters for the IPS e.max Ceram Stains and the Zenostar Art Module materials can be found under "Firing parameters"
on the pages 55 and 56.
Glaze firing
For glaze firing, the same procedure is used as for monolithic
restorations fabricated in the Staining Technique. Please
observe the notes on the pages 55 and 56.
Completed restoration