Ivoclar Vivadent Telio Lab - Manual (Page 27)

Metal bond
The for chemical metal bond, the use of SR Link is recommended.
– After blasing, remove blasting medium residue by
tapping the framework against the work surface
rather than by cleaning with steam or blasting
with oily compressed air.
– Start with the application of SR Link immediately.
Apply SR Link with a clean disposable brush and
allow it to react for 3 minutes.
Telio Lab Opaquer
Mix Telio Lab Opaquer with Telio Lab Opaquer Liquid
to a flowable consistency, cover it, and let the mate-
rial rest for approximately 2-3 minutes. Subsequently,
apply the material in an evenly covering layer on the
surface using a brush. Telio Lab Opaquer requires a
drying time of approximately 15 minutes.
The final polymerization of the Telio Lab Opaquer is carried out together with Telio Lab Dentin.
The metal-supported temporary restoration may now be fabricated in the casting, injection or veneering
technique:
• Casting technique – see page 15
• Injection technique – see page 18
• Temporary veneer – see page 22
Applying SR Link
Apply an even, covering layer on the bridge framework.
Important
Do not blast the framework with oily compressed air or steam when using SR Link! Do not
touch the surface once it has been cleaned!
Important
Check setting with an instrument before continuing with the next working steps.
Telio
Lab
–
Metal-supported
temporary
27