Ivoclar Vivadent Telio Lab - Manual (Page 16)

– The inihibition layer is dabbed off using a sponge.
– Now the reduced and stained restoration is replaced in the silicone key and positioned on the wetted
and isolated model.
Casting the Telio Lab Transpa Incisal materials
– Pour the desired amount of Telio Lab Cold Liquid into a clean mixing beaker.
– Dispense the same amount of powder into a second mixing beaker.
– Subsequently, add the powder to the Cold Liquid and mix without creating air bubbles using a
modelling spatula, cover the beaker, and allow a dough time of approximately 2 minutes.
– Pour the now well-flowable Telio Lab resin evenly into the silicone key and polymerize.
Checking the cut-back Application of SR Composiv Individualization using Telio
Stains Removal of the inhibition layer
16
The respective light-curing Telio components are pre-polymerized to ensure that they stay in place and to
be able to apply a further layer. However, final polymerization of the entire restoration is always required.
Polymerization device Manufacturer Pre-polymerization Polymerization
Quick Ivoclar Vivadent 40 s (SR Composiv 60 s) ––
Lumamat ® 100 (Targis ® Power
Upgrade)
Ivoclar Vivadent Exclusively use Quick for pre-polymerization.
11 min
(program P 2)
Spectramat ® Ivoclar Vivadent 5 min (Telio Stains 2.5 min) 5 min