Ivoclar Vivadent IPS e.max Ceram - Manual (Page 53)

53
Layer the restoration according to the clinical requirements using
IPS e.max Ceram Dentin and IPS e.max Ceram Incisal.
Individual layering with the Impulse and Transpa materials enables
mamelons, opalescent and translucent effects to be achieved.
1 st Dentin/Impulse/Incisal firing
Individual layering with Dentin, Impulse and Incisal materials
The anatomical form is adjusted and supplemented using Incisal and
Transpa materials. Several corrective firing cycles can be conducted
using the same firing parameters.
2 nd Dentin/Corrective firing
Compensate for the anatomical shape using Transpa and Incisal materials.
Evenly apply glaze paste to the surface of the veneers. If
desired, Essence material and/or Shades can be used to apply
characterizations.
Stains and Glaze firing
Conduct the Stain and Glaze firing with Essence, Shades and Glaze materials.
Remove large amounts of die material using a grinding disk.
Subsequently, clean the inner aspects of the veneers with polishing
jet medium at approx. 1 bar pressure.
Conditioning the veneers for adhesive luting
Before the veneers are placed, the inner aspects have to be etched
with IPS Ceramic Etching Gel for 20 seconds and subsequently
silanized with Monobond-S.
Divesting of veneers
Divest the veneers with polishing jet medium at max. 1 bar (15 psi) pressure.
Important :
IPS e.max Ceram veneers have to be adhesively cemented.
T
°C/°F
770/
1418
B
°C/°F
403/
757
S
min
8:00
t ➚
°C/°F/min
50/
90
H
min
1:00
V
1
°C/°F
450/
842
V
2
°C/°F
769/
1416
T
°C/°F
770/
1418
B
°C/°F
403/
757
S
min
8:00
t ➚
°C/°F/min
50/
90
H
min
1:00
V
1
°C/°F
450/
842
V
2
°C/°F
769/
1416
T
°C/°F
740/
1364
B
°C/°F
403/
757
S
min
8:00
t ➚
°C/°F/min
50/
90
H
min
1:00
V
1
°C/°F
450/
842
V
2
°C/°F
739/
1362