IHSE USA 437 Series DDXi DVI/VGA Extender - Manual (Page 53)

APPENDIX F: AUDIO/SERIAL UPGRADE
53
Audio Interface - Set Up and Operation
The audio interface is line-level and is designed to take the output from a sound card
(or other line-level) source and be connected to a set of powered speakers at the
other end of the link. Stereo audio may be transmitted either way across the link
(simultaneously). No set up is required unless a microphone is connected to the
remote unit.
Connect up the extender as follows:
Take the line-level output from your sound card (green connector) and connect to
‘Line In’ on the extender.
A set of powered speakers may be connected directly to ‘Line Out’ at the opposite
end of the link.
Audio Interface - Using a Microphone
A microphone may be plugged into the ‘Line In’ connector on the Remote Unit.
There are two ways of setting up a microphone:
•
The Local Unit’s ‘Line Out’ connection should normally be wired to the
microphone input (Red) on your sound card. The sound card should then be set
up to provide additional amplification (+20dB). This is the preferred connection
method.
•
Alternatively, the Remote Unit itself can provide microphone amplification. To set
this, open up the Remote Unit and locate the jumper labeled ‘MIC’ on the
daughter board. Connect this jumper across the pins. The Local Unit’s ‘Line Out’
connection should then be wired to ‘Line In’ (Blue) on your sound card.
If your microphone is already amplified, follow the second method but DO NOT install
the amplification jumper in the Remote Unit.