IHSE USA 437 Series DDXi DVI/VGA Extender - Manual (Page 34)

DDXI DVI/VGA KVM EXTENDER FAMILY
34
Factory Reset
Use the Factory Reset submenu to reset the unit to factory defaults, save
user presets or restore user presets
Figure 18 Factory Reset sub-menu
Auto Configuration
Use the Auto Configuration submenu to define whether the Local unit
carries out automatic detection of the number of pixels per line and the best
phase after a mode change (a change of screen resolution and/or refresh
rate at the graphic source). Using automatic detection (while displaying an
appropriate test pattern) ensures an optimized image but the procedure introduces a
delay in the picture appearing on the remote console screen. If you want the picture
to appear as fast as possible, and can tolerate a non-optimized image, you may want
to disable this feature. Please note that Auto Configuration is disabled in the default
factory settings.
To view the Auto Configuration menu, select the Tools icon from the main menu and
then select the Auto Configuration icon.
Figure 19 Auto-Configuration submenu
Disable Automatic detection of pixels per
line and phase after a mode change
Enable Automatic detection of pixels per
line and phase after a mode change
Back to Tools menu
Factory Reset: Restore originally equipped
Setup data
Restore User Data: Restore previously
saved User data
Save actual User Data in internal memory
Back to Tools menu