beautypg.com

Assembly—slug-mount install track – Harken HC7906 18 mm Battcar Switch System User Manual

Page 9

background image

9

Loosen top screw. Slide top track up and

position next 2.05 m (6'8

7

/

8

") track.

Mast-up: Tighten bottom screw to

hold track.

Slide 19 mounting slugs and splice slug

into mast groove.

Mast-up: Tape in place.

One drop blue Loctite

®

adhesive into

each hole.

Hold full-length track piece up to mast.

Loosely install top screw.

Use putty knife to slide additional slugs

and splice slug into place. Loosely install

all nineteen 5 mm x 20 mm screws.

Repeat until full-length tracks installed.

Hold switch in place and make sure there

is 64 mm (2

1

/

2

") below for loading cars.

Assembly—Slug-Mount

Install Track

Slide tracks up enough to fit next track.

Mast-up: Hold upper tracks. Loosen screw

that holds tracks. Slide track up. If screws

bind in mast groove opening, loosen them

until track slides. Tighten new bottom

screw securely.

CAUTION! Do not let tracks
drop. Severe injury to hands
and/or fingers can result.

Loctite is a registered trademark of Henkel AG & Company KGaA.