Harken HC7906 18 mm Battcar Switch System - Manual (Page 14)

14
Assembly—Drill and Tap Mount Install Track
HC10417 only
If shortening is required, use lines scribed on
switch track to indicate cut line. Make sure you
add 254 mm (10") to the upper track length.
Before mounting track, move endstops and
tether to new locations.
Tip: Move one at a time so you can see how
the line is run through the deadend hole.
Carefully align track. Use transfer punch to mark
holes. Drill, tap, and mount as directed above.
Important! Do not use epoxy or threadlocker
on screws because gate track is removed for
loading cars.