Harken HC7906 18 mm Battcar Switch System - Manual (Page 13)

13
Assembly—Drill and Tap Mount Install Switch
Insert splice link into switch track.
Using a plastic hammer, tap link into place.
Carefully align track and tape in place.
Use a transfer punch to mark a single hole.
Remove track. Drill and tap. Fasten with
single screw, no adhesive.
Realign track and mark a second hole using
transfer punch. Screw to mast using two
screws, no adhesive.
Mark remaining holes using transfer punch.
Remove track. Drill and tap remaining holes.
Mount switch to mast using threadlocker
or epoxy on screws as required.