Harken HC7906 18 mm Battcar Switch System - Manual (Page 11)

11
Assembly—Slug-Mount Install Switch
Install screw in open slug hole using blue
Loctite adhesive.
Round slug will go below/flat slug above.
Install connector screw using blue Loctite ®
adhesive on screw. If necessary loosen
plastic locator screws.
Install switch over slugs so plastic locator
screw is through center hole.
Remove plastic locator screw and replace with
mounting screw. Use blue Loctite adhesive.
Loctite is a registered trademark of Henkel AG & Company KGaA.