Options for snaking stay into foils – Harken 7311.10 Cruising Jib Reefing & Furling User Manual
Page 8
Preassembly
Toggle Deductions/Stay Into Foil Options
Most boats have a chainplate with
a single tang. If boat has two plates
forming a jaw, reverse eye/jaw
toggle so eye is down.
Important: Remove black plastic
caps and install them so that crosspin
will be 90 degrees to main clevis pin.
Use dimensions of the Harken toggle below to build stay to correct length.
Tip: Turnbuckles should be 1/2 to 2/3rds open to allow shortening for
new wire stretch and allows fine tune adjustment of mast rake.
1. Swage stud at end of wire.
2. Open end of wire and install Norseman or Sta-Lok
®
stud after foil is assembled.
3. When using smaller wires, marine eye may fit. See page 14.
4. Rod adapter nosepiece for Harken rod adapter stud.
Crosspin
Tang
Attachment
For tang-down
installations,
switch plugs
to this position.
Options for Snaking Stay into Foils
Fork
Attachment
Crosspin
Eye/Jaw Reversible Toggle
Unit 1
3
1
/
4
" (83 mm)
Unit 2
4" (102 mm)
Unit 1
*2
5
/
16
" (59 mm)
**2
11
/
16
" (68 mm)
Unit 2
*2
5
/
8
" (67 mm)
**3
1
/
4
" (83 mm)
Unit
Clevis Pin
1
1/2" (12.7 mm)
2
5/8" (15.9 mm)
Eye/Jaw Reversible
Make sure your
toggle looks like this!
Unit
Clevis Pin
1
1/2" (12.7 mm)
2
5/8" (15.9 mm)
Jaw/Jaw
Unit 1
3" (76 mm)
Unit 2
3
9
/
16
" (90 mm)
Unit
Clevis Pin
1
3/4" (19.1 mm)
2
5/8" (15.9 mm)
Stud/Jaw
Unit
Clevis Pin
1
1/2" (12.7 mm)*
5/8" (15.9 mm)**
2
5/8" (15.9 mm)*
3/4" (19.1 mm)**
Long Link
Plate w/Toggle
Unit 1
3
7
/
8
" (98 mm)
Unit 2
5
1
/
4
" (133 mm)
Unit 1
8
7
/
8
" (225 mm)
Unit 2
11
5
/
8
" (295 mm)
8
Unit 1, 2 Cruising
10/11/10
WARNING! Using a threaded nosepiece with only
adhesive at the upper rod eye terminal may result
in headstay system failure which can cause an
accident, damage to your vessel, personal injury,
or death. See www.harken.com for additional
safety information.
Make sure your
toggle looks like this!
Unit
Thread
1
5/8" - 18LH
2
3/4" - 16LH