Harken 7311.10 Cruising Jib Reefing & Furling - Manual (Page 18)

Assembly Attach Toggle/Long Link Plate
Make sure drum assembly
has four threaded holes
in base.
Determine height of long link
plates to provide anchor
clearance and cut to length.
Cut at scribe mark. Deburr
edges.
Make sure shallow jaw is up.
Connect eye to toggle jaw
using special clevis pin.
Secure using cotter pin.
Fasten second long link plate to drum
assembly and secure to clevis pin using
locknuts.
Toggle For Long Link Plates
18 Unit 1, 2 Cruising 08/23/10
WARNING! Stay must attach
to toggle. Do not attach stay
to crosspin at drum assembly
because crosspin and plates
may fatigue and break causing
an accident, damage to your
vessel, personal injury, or death.
See www.harken.com for
additional safety information.
Apply Isolator.
Fasten one long link plate to drum assembly
using fasteners. Use blue Loctite ® on screws.