beautypg.com

Harken 7410.10 MKIV Jib Reefing & Furling User Manual

Page 24

background image

Commissioning

leading line to Cockpit

24

MKIV Unit 0

Note: As furling line lead changes, make sure line

doesn’t chafe against line guard. Rotate line guard

if necessary.

Drum Empty

(sail furled)

Drum Full

(sail unfurled)

Position 7401 Forward Stanchion Block so line enters

drum at right angles to headstay and centers vertically

in opening. Install so line is inside stanchion.

Correct block position is critical to even line

spooling and ease of furling.

7401 Forward Stanchion Block

Install 7403 Outboard Stanchion Blocks so line is

outside stanchions.
Number and placement of leads depends on boat

length and number/configuration of stanchions.

7403 Outboard Stanchion Blocks

Mount 7402 Ratchet Stanchion Block as furthest-aft

lead to prevent line overrides in drum when unfurling.

Position ratchet block so line turns at least 90°.
Install so line is inside stanchion.
Lead line through block so ratchet makes

clicking sound when pulling line to furl sail.
Tip: Make sure ratchet switch is in “ON” position. If there is

no clicking sound, lead line through block in opposite direction.
Lead line to Furling Line Cleat in cockpit.

7402 Ratchet Stanchion Block

Install so line is angled as shown.

Use #10 (5 mm) fasteners.

HCP168 Furling Line Cleat

Run line through enclosed window in guard and into hole

in bottom plate of spool. Tie a small overhand knot and

pull it up under drum assembly.

Mount lead blocks

Furling line can be led down either side of boat. If boat is in slip, consider mounting opposite dock.
Remove four screws on stanchion blocks. Clamp blocks to stanchions. See instructions below.
Tip: Start all four screws before tightening.

WARNING! Lead line through enclosed window. If

line is led through opening between two enclosed

windows it can ride above lineguard and jam

furler which can cause loss of control of boat.

Note location of sun cover. Charge system by rotating furler to wrap line on drum.
Tip: Sun cover to starboard—turn clockwise to charge. Sun cover to port—turn counter-clockwise.

Tension line while charging.

Enclosed Window

7403

OUTBOARD

STANCHION

BLOCK

7403

OUTBOARD

STANCHION

BLOCK

7402

RATCHET

STANCHION

BLOCK

STERN

BOW

7401

FORWARD

STANCHION

BLOCK

7403

OUTBOARD

STANCHION

BLOCK

This manual is related to the following products: