Harken 7410.10 MKIV Jib Reefing & Furling - Manual (Page 16)

Assembly foils/Connectors
16 MKIV Unit 0
Use bushings, connector, wedge, and
red Loctite ® in other screw holes and
insert into other foil. Then inject 1/4–1/3 ml
of adhesive.
Inject only a small amount. A Unit 0 will
only take 1 /
4
to 1 /
3
of a graduation mark.
Tip: When you see a small amount of
adhesive enter one of the screw holes,
stop—you have applied enough adhesive.
Use “ml”
marks to
estimate 1 / 4
to 1 /
3
ml of
adhesive Stop when you see a small
amount of adhesive enter
one of the sdrew holes.
Tighten screws into connector holes. Make
sure a drop of red Loctite ® entered each
screw hole. If not, apply to screw.
Red Loctite ®