Guntermann & Drunck TripleMUX - Manual (Page 27)

Guntermann & Drunck GmbH Installation and operating manual
TripleMUX/QuadMUX
Pressing ENTER will run the function and the following info window will be
opened.
Info TripleMUX
This function will delete
all settings.
Press Enter to continue
or
Esc to cancel
Confirm this once more by pressing the
ENTER key. The window will change to
the FUNCTION menu.
5.2.3 Cascade setup
Note:
To run this function you need to be logged on as a master!
In the Cascade Setup menu you determine which terminal has been
connected to the four possible PC channels. The following are available:
• PC (default assignment)
• MUX4 (permits the number of computers to be increased to up to 16
computers by using a miniMUX4. However, the access to the multi-way
graphic is only possible on the PCs directly connected to the TripleMUX.
All PCs connected via a miniMUX4 to the TripleMUX transmit only one
graphics signals on the other hand.).
A comprehensive description of cascading the TripleMUX using a miniMUX4 can
be found in the relevant manual.
Open the AdonIS for the TripleMUX using the HotKey combination you have
set or using the default HotKey
CRTL + NUM .
In the open AdonIS ("Select Scene" menu) press the
F4 key
In the open "Cascade Setup" menu you set for each channel which device is
connected here. The
Space key can be used to change the entries. By default
the value here is set to "PC". Pressing the Space key allows you to switch the
entry to "miniMUX 4".
To save your inputs, press the
F1 key. This will return you to the Select Scene
menu.
Page 27