Guntermann & Drunck TripleMUX - Manual (Page 24)

Guntermann & Drunck GmbH Installation and operating manual
TripleMUX/QuadMUX
5.2.2.15 Setting the Accesskey
The actual switchover process in QuickAccess is carried out via the keyboard.
As the default value the F1 – F10 keys are set as Accesskeys. If within a scene
you press the keys
CRTL + F 1 , the keyboard and mouse will be assigned to
the computer with the screen being displayed via the CPU 1 port on the
TripleMUX. With three monitors this should normally be the left-hand one.
CRTL + F 2 therefore switches the keyboard and mouse to the second monitor,
and CRTL + F 3 to the third monitor. The scene display (see. chap. 5.2.2.6 )
also changes at the same time.
If you want to change the default F1- F10 , move the cursor onto the Accesskey
option in the CONSOLE SETUP menu.
By pressing the SPACE key you can then switch between the following
alternatives:
NUM 0 – 9 / F1 – F10 / A - K.
ENTER confirms the change. To save the setting, close this menu using F 1 .
5.2.2.16 Changing the user password
Note:
To run this function you need to be logged on as a master!
If you want to change the default value (accessed using ENTER ) and protect
the TripleMUX with a user password, move the cursor in the Console Setup
menu to the "User Password" field and then press the
ENTER key.
Another menu will appear which prompts you to enter the new password.
C H A N G E P A S S W O R D T r i p l e M U X
Please enter your new
password twice:
[Min. 4, max. 12 characters]
Esc Enter
The cursor is located in the input box and you can enter the password, which
may contain a minimum of 4 and a maximum of 12 characters.
Default: No password.
Page 24