Guntermann & Drunck TripleMUX - Manual (Page 17)

Guntermann & Drunck GmbH Installation and operating manual
TripleMUX/QuadMUX
5.2 The individual functions
Key F1 Back to the SELECT SCENE menu
5.2.1 AutoScan function
Key F2 Triggering the AutoScan function
Activating the AutoScan function causes the automatic interconnection of all
channels.
Even unassigned channels or computers which are switched off can be
included in the AutoScan function (e.g. to check the boot phase).
5.2.1.1 Opening the AutoScan function
Open the AdonIS; key combination (default): CRTL + NUM . You can open the
AutoScan function, as described above, directly from the Select Scene menu,
as well as from the FUNCTION menu.
Then press F 2 .
The enabled channels will now be switched to your console in sequence for
approx. 5 seconds. This time period can be changed
(see point 5.2.1.4)
5.2.1.2 Identifying the AutoScan function
The activated Scan function is indicated by the "Scan" display.
001 (Scene name, can be edited)
TripleMUX (Console name, can be edited)
Scan ( Active Scan function )
5.2.1.3 Clearing the AutoScan function
In the event of inputs via the keyboard or mouse, the AutoScan function is
paused and is only enabled once again after the final character. The function is
closed by opening the AdonIS (
CRTL + NUM ) or a scene selection via HotKey.
The Scan display will go out.
5.2.1.4 Setting the AutoScan time
see point 5.2.2.1
Page 17