Grandstream GXW42xx User Manual - Manual (Page 56)

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 54 OF 62
Authenticate ID SIP service subscriber’s Authenticate ID used for authentication.
Can be identical to or different from SIP User ID.
Password SIP service subscriber’s account password for GXW42XX to register
to (SIP) servers of ITSP.
Name Any name to identify this specific user.
Profile Select the corresponding Profile ID (1/2/3/4)
Enable FXS (TR-069) Enable or disable the FXS port.
Advanced Port
Settings
Offhook Auto-dial Configure an auto dial number when offhook.
Hunting Group Assign this port to a certain hunting group
Request URI Routing
ID
If configured, device will route the incoming call to designated port by
request URI user ID in SIP INVITE.
FXO Mapping Map to FXO Port # This is used only when peering with a Grandstream GXW410x.
Default 1, Supported values are 1-8, meaning line 1 to 8 of the
GXW410x device where the port will be mapped to.
Map to FXO Gateway
IP
This is used when peering with an FXO gateway of any brand. You
have to specifically mention the IP and sip port where call will be sent
to.
And Port Sip port that will be annexed to the IP address above.
SAVING THE CONFIGURATION CHANGES
After user makes a change to the configuration, press the “Update” button in the Configuration Menu. The
web browser will then display a message window to confirm saved changes.
Grandstream recommends reboot or power cycle the gateway after saving changes.
REBOOTING FROM REMOTE
Press the “Reboot” button at the bottom of the configuration menu to reboot the phone remotely. The web
browser will then display a message window to confirm that reboot is underway. Wait 30 seconds to log in
again.