Grandstream GXW42xx User Manual - Manual (Page 52)

FIRMWARE 1.0.5.8 GXW42XX USER MANUAL PAGE 50 OF 62
{ ^1900x. | <=1617>[2-9]xxxxxx | 1[2-9]xx[2-9]xxxxxx | 011[2-9]x. | [3469]11 }
Explanation of example rule (reading from left to right):
•
^1900x. - prevents dialing any number started with 1900
•
<=1617>[2-9]xxxxxx - allows dialing to local area code (617) numbers by dialing 7
numbers and 1617 area code will be added automatically
•
1[2-9]xx[2-9]xxxxxx |- allows dialing to any US/Canada Number with 11 digits length
• 011[2-9]x. - allows international calls starting with 011
[3469]11 - allow dialing special and emergency numbers 311, 411, 611 and 911
Note: In some cases user wishes to dial strings such as *123 to activate voice mail or other
application provided by service provider. In this case * should be predefined inside dial plan
feature and the Dial Plan will be: { [x*]+}.
Use # as Dial Key Allows users to configure the “#” key as the “Send” (or “Dial”) key. If set to “Yes”, “#” will send
the number. In this case, this key is essentially equivalent to the “Dial” key. If set to “No”, this
“#” key can be included as part of number.
No Key Entry
Timeout
Default is 4 seconds. Call will be completed within this time interval if no additional key entry
occurs.
Off-Hook Auto-
Dial Delay
Determines how many seconds after off-hook to wait before autodialing the extension set
under Advanced Port Settings. The range is 0 to 60 seconds.
Disable Call
Waiting
Default is No. If set to YES Call Waiting indication information will not be provided to analog
phone connected to this FXS port.
Disable Call
Waiting Caller ID
Default is No. If set to YES Call Waiting caller ID will not be provided to analog phone
connected to this FXS port.
Disable Call
Waiting Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting call arrives.
The CWCID will still be displayed.
Disable Receiver
Offhook Tone
Default is No. If YES, ROH tone will not be played after off hook for 60 seconds.
Disable Reminder
Ring for On-Hold
Call
Default is No. This is to disable the Reminder Ring that is played when a call is waiting on hold
and the analog phone goes on-hook.