beautypg.com

English, Virtual speaker – Denon ADV-M71 User Manual

Page 9

background image

9

ENGLISH

AC 120V 60Hz

UNSWITCHED

60W MAX

AC OUTLET

AC 120V 60Hz

UNSWITCHED

60W MAX

AC OUTLET

B

VIRTUAL SPEAKER

B

VIRTUAL SPEAKER

CAUTION:
• Only one cassette deck can be connected to the ADV-M71 using system connections. System operations cannot be performed properly if

two cassette decks are connected using system connections.

• Whenever the power operation switch is in the STANDBY position, the unit is still connected to AC line voltage.
• Please be sure to unplug the power cord when you leave home for, e.g.,a vacation, etc.

Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to
Article 820-40 of the NEC which provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point
of cable entry as practical.

System operations
Such system operations as the timer and the auto power on functions, as well
as remote control operations cannot be performed unless all the RCA pin-plug
cords and system connector cords are connected between the units, so be sure
to make all the connections properly as shown in the diagram. Also,
disconnecting system connectors while the system is operating may result in
malfunctions. Be sure to unplug the power cord before changing connections.

NOTES:
• Do not plug the power cord into the power outlet until all connections are

completed. Be sure to interconnect the channels (L to L (white) and R to R
(red)) properly, as shown on the diagram.

• Use the AC OUTLET for audio equipment only. Do not use them for hair

driers, etc.

• Insert the plugs securely. Incomplete connections may result in noise.
• Be sure to connect the speaker cords between the speaker terminals and

the speaker systems with the same polarities ( + to +, – to – ). If the
polarities are switched, the sound at the center will be weak, the position
of the different instruments will be unclear, and the stereo effect will be
lost.

• After unplugging the power cord, wait about 5 seconds before plugging it

back in.

• Note that setting the connection cords (pin-plug cords) next to the power

cords may result in humming or other noise.

MD recorder

(sold separately)

Cassette deck

(DRR-M31)

(sold separately)

ADV-M71

DRR-M31

(Horizontal installation)

Install the sets as shown in one
of these diagrams. In either
case, be sure that the DVD
surround receiver’s ventilation
holes are not obstructed.

ADV-M71

DRR-M31

(Vertical installation)

This manual is related to the following products: