GAI-Tronics 13363 Addressable Amplified Speakers Installation and Operation Manual - Manual (Page 53)

Pub. 43004-034F
Model 13353, 13363, and 13373 Addressable Amplified Speakers Page 48 of 52
e:\radio products-current release\43004\43004-034f\43004-034f.doc
03/15
Terminal Strip Designations
The wiring terminal strip, TB101, is located on the rear section of the speaker assembly. The screw
terminal designations for all models are as shown below. Refer also to Figure 9.
Terminal Strip
Label
Function
15 VDC POWER + External power source (positive)
15 VDC POWER − Ground reference
AUDIO IN 600

L1
Positive audio input
AUDIO IN 600

L2
Negative audio input
PAGE CTRL L1 Active low signal to activate speaker assembly
PAGE CTRL L2 Ground reference
AUDIO OUT 600

L1
Positive audio output
AUDIO OUT 600

L2
Negative audio output
OUTPUT CTRL + Output control to the Model 530-001 Strobe or control relay
OUTPUT CTRL − Ground reference
Field Installed Options
Model SPK200 Solar Interface Kit
The Model SPK200 Solar Interface Kit provides battery recharging when an external power source is not
available. This option is supplied with a terminal block, battery charge regulator module, solar mounting
bracket, wiring harness, and the necessary mounting hardware for the components. This option provides
a complete solar charging system when purchased with the GAI-Tronics Model RFP7784-108 Solar
Panel. Refer to Pub. 43003-039 for solar panel installation details. This kit must be used in conjunction
with the XB001 External Long-Life Battery Enclosure and the 40201-008 18 Ah battery.
Model XB001 External Long-Life Battery Enclosure
The Model XB001 External Long-Life Battery Enclosure includes a NEMA 4 weatherproof enclosure
with battery mounting bracket, a sealed 15 V dc external receptacle, and mating speaker power
connection cable. The required Model 40201-008 18 Ah battery is purchased separately.
This assembly allows the Addressable Amplified Speaker to be installed within two feet of the
weatherproof enclosure for true battery-powered operation. Combining this kit with the Model SPK200
Solar Panel Interface Kit and Model RFP7784-108 Solar Panel can provide a completely wireless
operation (if RF operation is used). If the application is only temporary, the speaker can easily be
“unplugged” from the battery enclosure and relocated or stored. Refer to Pub. 43003-037 for installation
details.